Numéro
J. Phys. IV France
Volume 09, Numéro PR9, September 1999
3rd European Mechanics of Materials Conference on Mechanics and Multi-Physics Processes in Solids : Experiments, Modelling, Applications
Page(s) Pr9-333 - Pr9-340
DOI https://doi.org/10.1051/jp4:1999934
3rd European Mechanics of Materials Conference on Mechanics and Multi-Physics Processes in Solids : Experiments, Modelling, Applications

J. Phys. IV France 09 (1999) Pr9-333-Pr9-340

DOI: 10.1051/jp4:1999934

Simulation of stresses, residual stresses, and distortion in stepped cylinders of AISI 4140 due to martensitical hardening by immersion cooling

M. Ehlers, H. Müller and D. Löhe

Institute for Materials Science and Engineering I, Karlsruhe University, 76128 Karlsruhe, Germany


Abstract
Heat treatment improves mechanical properties of steel parts, but also causes residual stresses and distortion. Stresses and deformation occurring during heat treatment can not be measured in-situ with appropriate temporal and spatial resolution. In order to evaluate the processes occurring in the workpiece during quenching as well as the residual stresses and distortions, numerical methods have to be used. Heat conduction, phase transformations, and mechanical behaviour of the material as well as the couplings between the processes such as transformation plasticity have to be modeled for the simulation of steel hardening. Temperature and phase dependent properties (including TTT-data) have to incorporated into calculations. One of the major factors determining the evolution of stress and deformation is the heat-transfer coefficient between component and quenching medium. For vapourizing liquids, heat transfer depends on temperature and location. But heat transfer is not only influenced by the quenchant but also by part geometry and size. Stepped cylinders of AISI 4140 steel were quenched in water and oil. Both experimental measurements and numerical calculations were carried out. The variation of dive-in direction strongly influences the rewetting of the specimen surface and therefore the cooling behaviour, stress and deformation evolution, and resultant residual stresses and distortion. Excellent agreement is obtained between calculated and experimental results.



© EDP Sciences 1999