Numéro
J. Phys. IV France
Volume 07, Numéro C3, August 1997
EURODYMAT 1997 - 5th International Conference on Mechanical and Physical Behaviour of Materials under Dynamic Loading
Page(s) C3-571 - C3-576
DOI https://doi.org/10.1051/jp4:1997398
EURODYMAT 1997 - 5th International Conference on Mechanical and Physical Behaviour of Materials under Dynamic Loading

J. Phys. IV France 07 (1997) C3-571-C3-576

DOI: 10.1051/jp4:1997398

Behavior of Quenched and Tempered Steels under High Strain Rate Compression Loading

L.W. Meyer, K. Seifert and S. Abdel-Malek

TU Chemnitz-Zwichau, Lehrstuhl Werkstoffe des Maschinenbaus, 09107 Chemnitz, Germany


Abstract
Two quenched and tempered steels were tested under compression loading at strain rates of [MATH] and [MATH]. By applying the thermal activation theory, the flow stress at very high strain rates of 105 to 106 s-1 is derived from low temperature and high strain rate tests. Dynamic true stress - true strain behaviour presents, that stress increases with increasing strain until a maximum, then it decreases. Because of the adiabatic process under dynamic loading the maximum flow stress will occur at a lower strain if the strain rate is incresed. Considering strain rate, strain hardening, strain rate hardening and strain softening, a constitutive equation with different additive terms is successfully used to describe the behaviour of material under dynamic compression loading. Results are compared with other models of constitutive equations.


Résumé
Deux aciers de traitement thermique ont été testés en compression à des vitesses de déformation de 2*102= s-1 et 103= s-1. En appliquant la théorie de l'activation thermique la contrainte d'écoulement aux très grandes vitesses de déformation de 103 à 106 s-1 est déduite à partir des tests à faible température et vitesse élevée. Le comportement dynamique contrainte vraie - déformation vraie montre que la contrainte augmente avec la déformation jusqu'à un maximum puis décroît. En raison du processus adiabatique pour un chargement dynamique, la contrainte d'écoulement maximale apparaît pour une déformation plus faible lorsque la vitesse de déformation augmente. Une équation constitutive avec des termes additifs divers a été utilisée avec succès afin de décrire le comportement du matériau sous compression dynamique, tout en considérant la vitesse de déformation, l'écrouissage, la vitesse d'écrouissage et l'adoucissement. Les résultats sont comparés avec ceux d'autres modèles d'équations constitutives.



© EDP Sciences 1997