Numéro
J. Phys. IV France
Volume 07, Numéro C3, August 1997
EURODYMAT 1997 - 5th International Conference on Mechanical and Physical Behaviour of Materials under Dynamic Loading
Page(s) C3-XXI - C3-XXXVI
DOI https://doi.org/10.1051/jp4:1997301
EURODYMAT 1997 - 5th International Conference on Mechanical and Physical Behaviour of Materials under Dynamic Loading

J. Phys. IV France 07 (1997) C3-XXI-C3-XXXVI

DOI: 10.1051/jp4:1997301

Material Property Requirements for Modelling Metal Machining

T.H.C. Childs

Leeds University, Department of Mechanical Engineering, LS2 9JT, Leeds, U.K.


Abstract
There are three types of mechanical property required for modelling metal machining : firstly the dependence of flow stress on strain, strain-rate and temperature when the heating rate is high too ; secondly parameters to describe the friction between the chip and tool ; and finally laws of high strain shear failure, including shear localsation. This paper is concerned with the first ; and the other two in so far as they relate to the first.


Résumé
La modélisation de la coupe des métaux exige trois types de propriétés mécaniques : premièrement, la relation entre la contrainte d'écoulement et la déformation, mais aussi la relation qui lie le taux de déformation et la température lorsque le taux d'échauffement devient élévé ; deuxièment, les paramètres permettant de décrire le frottement entre le copeau et l'outil ; finalement, les lois de rupture à taux de cisaillement élevés, avec localisation du cisaillement. Dans cet article, le premier type de propriétés est discrite, ainsi que les deux suivants lorsqu'ils ont en rapport avec le premier type.



© EDP Sciences 1997