| Numéro |
J. Phys. IV France
Volume 07, Numéro C1, Mars 1997
7th INTERNATIONAL CONFERENCE ON FERRITES
|
|
|---|---|---|
| Page(s) | C1-193 - C1-194 | |
| DOI | https://doi.org/10.1051/jp4:1997171 | |
7th INTERNATIONAL CONFERENCE ON FERRITES
J. Phys. IV France 07 (1997) C1-193-C1-194
DOI: 10.1051/jp4:1997171
1 Division of Ferrite, Samsung Corning Co., Ltd, 644 Jinpyung-dong, Gumi-city Kyungpook 730-340, Korea
2 Department of Inorganic Materials Engineering, Kyungpook Univ., 1730 Sankyuk-dong, Puk-gu, Taegu 702-701, Korea
© EDP Sciences 1997
J. Phys. IV France 07 (1997) C1-193-C1-194
DOI: 10.1051/jp4:1997171
Effect of Additives on the Magnetic Properties in Mg-Cu-Zn Ferrite
J. Park1, J. Kim2 and S. Cho21 Division of Ferrite, Samsung Corning Co., Ltd, 644 Jinpyung-dong, Gumi-city Kyungpook 730-340, Korea
2 Department of Inorganic Materials Engineering, Kyungpook Univ., 1730 Sankyuk-dong, Puk-gu, Taegu 702-701, Korea
Abstract
The adding effect of NiO, Cr2O3 on magnetic properties in Mg-Cu-Zn ferrite was investigated. The samples were prepared with conventional ceramic process at the sintering temperature of 1080°C. The two dopants were added in small quantities in steps of 0.3, 0.6, 0.9, 12 wt%, respectively. Microstructure and magnetic properties depending on temperature were investigated. The introduction of additives NiO, Cr2O3 in Mg-Cu-Zn ferrite can successfully promote the temperature properties in lowering the relative temperature coefficient. Key Words : Mg-Cu-Zn ferrite, initial permeability, relative temperature coefficient, curie temperature,
saturation magnetization, magnetocrystalline anisotropy.
© EDP Sciences 1997