J. Phys. IV France
Volume 134, August 2006EURODYMAT 2006 - 8th International Conference on Mechanical and Physical Behaviour of Materials under Dynamic Loading
|Page(s)||789 - 795|
|Published online||26 July 2006|
J. Cirne, R. Dormeval, et al.
J. Phys. IV France 134 (2006) 789-795
Determination of impact tensile properties of structural epoxy adhesive butt joints using a hat-shaped specimenT. Yokoyama and K. Nakai
Department of Mechanical Engineering, Okayama University of Science, Okayama 700-0005, Japan
Published online: 26 July 2006
The impact tensile properties of structural epoxy adhesive butt joints are determined with a modified version of the split Hopkinson pressure bar using a hat-shaped joint specimen. A typical two-component structural epoxy adhesive and two different adherend materials (Al alloy 7075-T6 and 99% pure titanium) are used in the adhesion tests. The impact joint tensile strength is evaluated from the applied tensile load history at failure. The corresponding static joint tensile strength is measured with an Instron testing machine using joint specimens of the same geometry as those used in the impact tests. It is demonstrated that the joint tensile strength increases definitely with increasing loading rate up to the order of 106 MPa/s, and decreases with increasing adhesive layer thickness up to nearly 180 m, depending on the adherend materials.
© EDP Sciences 2006