Numéro
J. Phys. IV France
Volume 03, Numéro C7, Novembre 1993
The 3rd European Conference on Advanced Materials and Processes
Troisiéme Conférence Européenne sur les Matériaux et les Procédés Avancés
Page(s) C7-1661 - C7-1664
DOI http://dx.doi.org/10.1051/jp4:19937260
The 3rd European Conference on Advanced Materials and Processes
Troisiéme Conférence Européenne sur les Matériaux et les Procédés Avancés

J. Phys. IV France 03 (1993) C7-1661-C7-1664

DOI: 10.1051/jp4:19937260

Interface characterization by pull-out test between high modulus polyethylene fibre and an unsaturated polyester resin

P. MASSE, J.P. CAVROT, P. FRANCOIS, J.M. LEFEBVRE and B. ESCAIG

Laboratoire de Structure et Propriétés de 1'Etat Solide, Université des Sciences et Technologies de Lille, Bâtiment C6, 59655 Villeneuve d'Ascq, France


Abstract
The observation of the pull-out conditions for a monofilament outside a matrix has been applied to a wide variety of organic or inorganic materials, as a direct method of interface characterization. In the case of High Modulus PolyEthylene (HMPE) it has been demonstrated that oxygen plasma treatments or gamma irradiation modify the fibre surface properties and improve the adhesion between the fibre and a resin. In this study, the effect of different plasma treatment times and the irradiation conditions leading to different gel fractions have been tested. For plasma treatments, an appreciable improvement occurs even for the lower residence times (2 sec). The gamma irradiation has only the same efficiency for the condition leading to a high gel fraction (0.75). These results agree with InterLaminar Shear Strengths (ILSS) values measured in three-point bending on HMPE/epoxy laminates.



© EDP Sciences 1993